Mortar for silicates and aerated concrete M15

KGS-M15 mortar is intended for thin-layer bricklaying of internal and external walls made of aerated concrete, silicate and ceramic blocks (bricks).

Lower shipping cost 67.65 €
Stock Status: In Stock
Delivery Status: 1-3 days
Shiping Time
5.84 €
Including Tax: 1.09 €
pcs

Description

Thin-Layer Mortar for Silicate and Aerated Concrete Blocks M15 Dublet

KGS-M15 adhesive is designed for thin-layer masonry of internal and external walls made of aerated concrete blocks, silicate blocks, and ceramic bricks.

KGS-M15 is a ready-to-use dry mix containing mineral binders, quartz fillers, and additives that improve the mortar's application properties. Once hardened, it is resistant to water and frost. It ensures thermal insulation in the joints between masonry elements, preventing the formation of thermal bridges.

Preparation of the Mortar

The KGS-M15 mortar should be prepared using a ratio of approximately 4.5 liters of water per 25 kg of dry mix.

Pour the dry mix into the measured amount of water and mix mechanically using a mixer or a concrete mixer until a uniform consistency is achieved.

Then, let it sit for about 5 minutes and mix again.

The fresh mortar should have the consistency of "thick cream."

After application to the masonry, the grooves created by the trowel should be uniform, without interruptions, tearing, or excessive spreading.

It is important to add the correct amount of water, as an improper ratio can alter the mortar's properties.

Technical Data

Strength class 15 MPa
Reaction to fire class A1
Dry density of hardened mortar approx. 1500 kg/m3.
Bulk density of dry mortar approx. 1600 kg/m3.
Correction time approx. 4 minutes.
Maximum filler fraction
Ready-to-work time approx. 2h.
Packaging 25 kg
Pallet 48 bags
Wall thickness Mortar quantity/m2 of wall Efficiency from 25 kg
12 cm 4.1 kg, 6.1 m2
18 cm 6.1 kg, 4.1 m2
24 cm 8.1 kg, 3.1 m2
30 cm 10.1 kg, 2.5 m2
36 cm 12.2 kg, 2.0 m2
44 cm 14.8 kg, 1.7 m2
The given efficiency is calculated for a block 22 cm high and a trowel with a tooth height of 10 mm. Only the horizontal joint was taken into account in the calculations.
Customer Reviews

Be the first to post a review for this product

Rate This Product

You must be signed in to rate this product

Similar Products