Description
EPIFIL H-50 epoxy putty and repair compound
Epifil H-50 is a two-component, water-soluble epoxy mass intended for leveling surfaces and filling gaps in plaster, concrete and stone.
The product is easy to spread, creating a smooth and hard layer that has very good adhesion to smooth and load-bearing surfaces.
The mass is resistant to mechanical damage and chemical factors, which provides a wide range of options when choosing a topcoat.
However, please remember that it is not a stand-alone coating and the surfaces covered with this putty should be painted with an appropriate topcoat before being put into operation.
Product highlights:
- The maximum thickness of one layer cannot exceed 5 mm.
- Most often used as a leveling layer before painting with Epimal 200 epoxy paint.
- Requires a porous surface to ensure adequate adhesion, e.g. concrete.
- Painted surfaces are not a good base for EPIFIL H-50.
- The product is durable for foot traffic only.
Substrate preparation:
- The substrate should be thoroughly cleaned, loose elements removed, degreased and vacuumed.
- Fresh concrete substrates can only be puttyed 4 weeks after application.
- Rust should be removed from the steel surface and degreased.
- Before using the mass, add the second ingredient (hardener) and mix the contents of the package thoroughly mechanically, avoiding the formation of air bubbles.
- After 5 minutes, the mass is ready for use.
- After adding the hardener, the mass should be used within 2 hours.
- Apply the product to the prepared surface with a putty knife or mason's trowel, pressing it to the substrate and carefully leveling the surface.
- After hardening, sanding with sandpaper is difficult due to the hardness of the mass.
- Primers and paints can be applied to the thoroughly dried and dust-free layer.
- It is important to ventilate the room until the smell disappears and do not use the mass without a hardener.
The video guide was developed in the epoch system with the Epifil H-50
Technical Data
Packaging | |
---|---|
set (A+B) 15 kg | |
Efficiency | |
approx. 0.5 m2/kg | |
Color | |
white to light gray | |
Character | |
I ingredients – white-gray paste | |
II component (Hardener E6) – colorless, thick liquid | |
The number of layers | |
depending on need | |
Thickness of one layer | |
up to 5mm | |
Overlay | |
putty or masonry trowel | |
Drying time | |
foot traffic after 24 hours | |
Complete hardening and loading | |
after 7 days | |
Wear | |
approx. 1.9 kg/m2 with a layer thickness of 1 mm |
Customer Reviews
Be the first to post a review for this product