Epoxy putty and repair compound Epifil H50

Epifil H-50 is a two-component, water-dilutable epoxy putty.

Lower shipping cost 9.23 €
GTIN: 5904922281347
Stock Status: In Stock
Delivery Status: 1-3 days
Shiping Time
103.01 €
Including Tax: 19.26 €
pcs

Description

EPIFIL H-50 epoxy putty and repair compound

Epifil H-50 is a two-component, water-soluble epoxy mass intended for leveling surfaces and filling gaps in plaster, concrete and stone.

The product is easy to spread, creating a smooth and hard layer that has very good adhesion to smooth and load-bearing surfaces.

The mass is resistant to mechanical damage and chemical factors, which provides a wide range of options when choosing a topcoat.

However, please remember that it is not a stand-alone coating and the surfaces covered with this putty should be painted with an appropriate topcoat before being put into operation.

Product highlights:

  • The maximum thickness of one layer cannot exceed 5 mm.
  • Most often used as a leveling layer before painting with Epimal 200 epoxy paint.
  • Requires a porous surface to ensure adequate adhesion, e.g. concrete.
  • Painted surfaces are not a good base for EPIFIL H-50.
  • The product is durable for foot traffic only.

Substrate preparation:

  • The substrate should be thoroughly cleaned, loose elements removed, degreased and vacuumed.
  • Fresh concrete substrates can only be puttyed 4 weeks after application.
  • Rust should be removed from the steel surface and degreased.
  • Before using the mass, add the second ingredient (hardener) and mix the contents of the package thoroughly mechanically, avoiding the formation of air bubbles.
  • After 5 minutes, the mass is ready for use.
  • After adding the hardener, the mass should be used within 2 hours.
  • Apply the product to the prepared surface with a putty knife or mason's trowel, pressing it to the substrate and carefully leveling the surface.
  • After hardening, sanding with sandpaper is difficult due to the hardness of the mass.
  • Primers and paints can be applied to the thoroughly dried and dust-free layer.
  • It is important to ventilate the room until the smell disappears and do not use the mass without a hardener.

The video guide was developed in the epoch system with the Epifil H-50

Technical Data

Packaging
set (A+B) 15 kg
Efficiency
approx. 0.5 m2/kg
Color
white to light gray
Character
I ingredients – white-gray paste
II component (Hardener E6) – colorless, thick liquid
The number of layers
depending on need
Thickness of one layer
up to 5mm
Overlay
putty or masonry trowel
Drying time
foot traffic after 24 hours
Complete hardening and loading
after 7 days
Wear
approx. 1.9 kg/m2 with a layer thickness of 1 mm
Customer Reviews

Be the first to post a review for this product

Rate This Product

You must be signed in to rate this product

Similar Products